Amana ASI2175GRS User Guide
![Amana ASI2175GRS Refrigerator manual cover](/images/vbKYexsyWtZosrXoBlAuxqry/thumbs/thumb175x175.webp)
To adjust the temperature, locate the control panel inside the refrigerator. Use the up or down arrows to set the desired temperature for both the refrigerator and freezer compartments.
First, check if the temperature settings are correct. Ensure that the doors are fully closed and the door seals are not damaged. Clean the condenser coils if they are dusty. If the problem persists, consider contacting a professional technician.
Locate the water filter compartment inside the refrigerator. Turn the filter counterclockwise to remove it. Insert the new filter and turn it clockwise until it locks into place. Run water through the dispenser for a few minutes to clear any air and impurities.
Water pooling could be due to a blocked defrost drain. Try clearing the drain with warm water or a drain cleaner. Ensure that the refrigerator is level to allow proper drainage.
It is recommended to clean the condenser coils every 6 to 12 months to ensure optimal performance and efficiency. Use a vacuum or brush to remove dust and debris.
Unusual noises can be caused by various factors such as a vibrating drip pan, a loose condenser fan, or ice buildup on the evaporator fan. Inspect these components and tighten or clean as necessary.
To reset the ice maker, locate the reset button on the ice maker unit. Press and hold the button for a few seconds until you hear a chime or click. This will initiate a reset cycle.
First, check if the light bulb is burnt out and replace it if necessary. If the bulb is fine, inspect the light switch to ensure it is not stuck or damaged.
To prevent frost buildup, ensure that the freezer door seals are intact and not allowing warm air to enter. Avoid leaving the freezer door open for extended periods and ensure it is closed properly after each use.
High energy consumption can result from incorrect temperature settings, frequent door opening, or dirty condenser coils. Adjust the temperature to recommended settings and keep the door closed as much as possible. Clean the coils regularly to maintain efficiency.