Whirlpool WRS325SDHZ Dispensing Guide
![Whirlpool WRS325SDHZ Refrigerator manual cover](/images/kSuDdqQhXKTvBKoCgZLErvbc/thumbs/thumb175x175.webp)
To clean the interior of your Whirlpool WRS325SDHZ refrigerator, unplug the appliance, remove all food items, and use a mixture of warm water and mild detergent. Avoid abrasive cleaners. Wipe down all surfaces and shelves, and dry thoroughly before reinserting food items.
If your refrigerator is not cooling, ensure that the temperature settings are correct, the vents are not blocked, and the door seals are intact. Check if the condenser coils are clean and the back panel is not obstructed. If the issue persists, consider contacting customer service for further assistance.
To replace the water filter, locate the filter compartment on the upper right side of the refrigerator interior. Turn the filter counterclockwise to remove it, insert the new filter, and turn it clockwise until it locks into place. Run water through the dispenser for several minutes to clear air and impurities.
The recommended temperature setting for the refrigerator compartment is 37°F (3°C), and for the freezer compartment, it is 0°F (-18°C). Adjust the settings accordingly to suit your preference or storage needs.
To reset the ice maker, locate the on/off switch or arm, turn it to the "off" position, wait 10 seconds, then turn it back to the "on" position. If the ice maker does not reset, unplug the refrigerator for a few minutes, then plug it back in and try again.
Water pooling at the bottom can be due to a clogged defrost drain. To fix this, locate and clear the drain tube using a small brush or warm water. Ensure that the refrigerator is level to prevent further drainage issues.
To adjust the shelves, first remove any items on them. Lift the front of the shelf and tilt it upwards to remove. Reposition the shelf at the desired height by aligning the shelf edges with the support brackets and gently lowering it into place.
Unusual noises may be caused by normal operational sounds like ice dropping, water filling the ice maker, or the compressor running. However, ensure the refrigerator is level and not touching any adjacent surfaces to prevent rattling sounds.
The air filter should be replaced every 6 months to ensure optimal air quality and odor control. Check the manufacturer’s instructions for details on the specific filter model needed for replacement.
If the control panel is unresponsive, check if the refrigerator is plugged in and receiving power. Try resetting the control panel by unplugging the refrigerator for a few minutes, then plugging it back in. If the issue continues, contact Whirlpool customer support for further assistance.