Samsung RB195AC User Manual
![Samsung RB195AC Refrigerator manual cover](/images/LxwcZkBYBFJuIArOMDNrZWbG/thumbs/thumb175x175.webp)
To change the water filter, locate the filter at the bottom right corner inside the refrigerator. Turn it counterclockwise to remove it, then insert the new filter and turn it clockwise until it locks in place. Run water through the dispenser for about 5 minutes to flush out any air and impurities.
Ensure that the refrigerator is plugged in and the door is closed properly. Check the temperature settings and make sure they are correctly set. Clean the condenser coils and ensure that there is enough ventilation around the unit. If the problem persists, contact Samsung support for further assistance.
To reset the ice maker, locate the reset button on the side or bottom of the ice maker. Press and hold the button until you hear a chime, which indicates that the ice maker has been reset.
Check if the refrigerator is level and adjust the leveling feet if necessary. Ensure that there are no items inside the refrigerator touching the walls. If the noise persists, it may be due to the compressor or fan, and a service technician should be consulted.
Unplug the refrigerator and locate the condenser coils at the back or bottom of the unit. Use a vacuum cleaner with a brush attachment or a coil cleaning brush to gently remove dust and debris from the coils. Plug the refrigerator back in once cleaning is done.
Routinely clean the condenser coils, replace the water filter every 6 months, and check the door seals for any gaps or damage. Also, regularly clean the inside of the refrigerator and ensure that the temperature settings are correct.
Press the 'Fridge' button on the control panel to adjust the refrigerator temperature and the 'Freezer' button to adjust the freezer temperature. Set them to your desired levels and allow 24 hours for the changes to take full effect.
The filter indicator light notifies you when it's time to replace the water filter. A red light typically means the filter needs to be changed soon. After replacing the filter, reset the indicator by pressing and holding the 'Alarm/Filter Reset' button.
Check if the door seals are clean and free from debris. Ensure that items inside the refrigerator are not obstructing the door. If the door still doesn't close properly, inspect the door alignment and adjust the hinges if needed.
Ensure that the freezer door is closed tightly and not left open for extended periods. Avoid placing hot or warm items directly into the freezer. Regularly defrost the freezer if frost buildup becomes excessive.