Samsung FlexWash WV60M9900A User Manual
![Samsung FlexWash WV60M9900A Washing Machine manual cover](/images/aILRcVMSAsYDTJXBZuyadCPo/thumbs/thumb175x175.webp)
To clean the detergent drawer, remove it from the machine by pulling it out and pressing down on the release lever. Rinse the drawer under warm water and use a soft brush to remove any residue. Allow it to dry completely before reinserting it into the washing machine.
Check for any clogs in the drain hose or filter. Ensure that the drain hose is not kinked or blocked. You may also need to clean the pump filter, which can be accessed through the small door at the bottom front of the machine.
Error code 4E indicates a water supply issue. Ensure that the water faucets are fully open and that the hoses are not kinked. Also, check the inlet filters for any blockages and clean them if necessary.
Regular maintenance includes cleaning the detergent drawer, inspecting and cleaning the drum, checking and cleaning the pump filter, and ensuring that the hoses are not blocked or damaged. Also, run a self-clean cycle monthly to keep the drum fresh.
The FlexWash feature allows you to wash two loads simultaneously. Use the main front-load compartment for larger loads and the top-load compartment for smaller, delicate items. Select the appropriate settings for each load on the control panel.
Ensure that the washing machine is level by adjusting the feet. Make sure the load is balanced inside the drum. Avoid overloading the washer, and separate heavy and light items for a more balanced load.
Leave the door and detergent drawer open after each wash to allow moisture to evaporate. Periodically run a self-clean cycle with a washing machine cleaner. Clean the door gasket and drum regularly to prevent mold and mildew buildup.
Error code 5E indicates a drainage issue. Check the drain hose for blockages or kinks and ensure that the pump filter is clean. Verify that the drain hose is installed at the correct height according to the user manual.
To calibrate the washing machine, ensure it is empty, then turn it on. Press and hold the Temp and Delay End buttons simultaneously for 3 seconds. Press the Start/Pause button to start the calibration cycle, which will take about 3 minutes.
Yes, you can use bleach. Add liquid bleach to the bleach compartment in the detergent drawer. Make sure to follow the manufacturer's instructions on the bleach container and do not exceed the max fill line. Run a wash cycle immediately after adding bleach.