Brother DCP-J785DW Safety Guide
![Brother DCP-J785DW manual cover](/images/wFYSOYcGQkepPMBGarAHgYdJ/thumbs/thumb175x175.webp)
To connect your Brother DCP-J785DW printer to a wireless network, press the 'Menu' button on the printer, select 'Network', then 'WLAN'. Choose 'Setup Wizard', select your network name, and enter the Wi-Fi password.
If your Brother DCP-J785DW is not printing, check if the printer is turned on, and ensure it is connected to the same network as your device. Verify that there are no error messages on the printer's display and check the ink levels. Restart the printer and your device if necessary.
To perform a factory reset on the Brother DCP-J785DW, press the 'Menu' button, navigate to 'Initial Setup', select 'Reset', then 'Factory Reset'. Confirm the reset by selecting 'Yes'.
To clean the print head, press 'Ink' on the printer's control panel, select 'Cleaning', and then choose either 'Black', 'Color', or 'All' to clean the respective nozzles.
The Brother DCP-J785DW printer supports a variety of paper sizes, including A4, Letter, Legal, Executive, A5, A6, and Photo (10x15 cm).
To configure scan settings, use the Brother ControlCenter software on your computer. You can set scan type, resolution, file format, and destination. Make sure the printer is connected to your computer via USB or network.
To replace an ink cartridge, open the ink cartridge cover, press the release lever to remove the old cartridge, and insert the new one until it clicks into place. Close the cover and follow the on-screen prompts to complete the process.
To update the firmware, download the latest firmware update tool from the Brother website. Connect the printer to your computer via USB or network, run the tool, and follow the on-screen instructions to complete the update.
For paper jams, turn off the printer and carefully remove any jammed paper from the paper tray or output slot. Check for any small pieces of paper stuck inside. Re-load paper properly in the tray and turn the printer back on.
To scan a document to email, use the Brother ControlCenter software. Select 'Scan to Email', configure your email settings and address, and click 'Start'. Ensure your email client is set up on your computer.