Set Up a Secure Powerline Network By Pairing (Optional)
LED and Item Legend
Paring is used to create or join a secure powerline network.
To create a secure powerline network: To join an existing secure powerline network:
FAQ (Frequently Asked Questions)
Existing Powerline Network
P a ir
Blinking
P a ir
On
Blinking
P a ir
Blinking
P a ir
On
Blinking
P a ir
1 Press the Pair button on one device.
1 Press the Pair button of any powerline device in the existing powerline network.
2 Press the Pair button on another device.
3 Done. 2 Press the Pair button on the new device.
3 Done.
Ethernet
Powerline
Power
DESCRIPTIONLED STATUS On/O
Blinking
Yellow-green
Red
O
On/O
The powerline adapter is on or o. Blinking every second: Pairing is in process. Blinking every 15 seconds: Power-Saving Mode is on.* Powerline network is in good condition. Powerline network is in poor condition. We recommend trying another wall socket.
The powerline adapter is not connected to any powerline network or is in Power-Saving Mode.
The Ethernet port is connected or not connected.
DESCRIPTIONITEM Press and hold for 1 second to set up or join a secure powerline network. Press and hold for 8 seconds to leave an existing powerline network. Press and hold for more than 15 seconds to reset the powerline adapter. Use as an electrical outlet expansion for power strip or household appliance. It can remove some electrical noise that might aect powerline performance.
* Five minutes after the device connected to the powerline adapter is turned o, the powerline adapter will automatically switch to Power-Saving Mode.
Q1. How do I reset my powerline adapter? A. With the powerline adapter connected to the electrical outlet, press and hold the Pair button for more than 15 seconds until the Power LED goes o
momentarily and comes back on.
Q2. What can I do if I don't have an Internet connection after Ive completed the setup? A1. Make sure the modem or router has an Internet connection. Connect a computer directly to the modem or router to check. A2. Make sure the hardware connection is correct. A3. Make sure the Powerline LEDs light up on all your powerline devices. If they do not, reset or pair all your powerline devices. A4. Make sure your computers IP address is in the same segment as your routers. A5. Make sure all powerline devices are on the same electrical circuit.
Q3. What can I do if a successfully-paired powerline device does not work after it has been moved to a new location? A1. Make sure all powerline devices are on the same electrical circuit. A2. Try to pair them again according to Set Up a Secure Powerline Network By Pairing. A3. If they still dont work, check for possible interference, such as washers, air conditioners or other household appliances that may be too close to one of the
powerline devices. Plug them into the integrated electrical sockets to remove some electrical noise.
http://www.tp-link.com/en/su
en
en