Sandstrom SRDAB10 Instruction Manual
![Sandstrom SRDAB10 manual cover](/images/joNBNUYXHHinaiMukreyrKgj/thumbs/thumb175x175.webp)
To set up your Sandstrom SRDAB10 Radio, plug it into a power source, extend the antenna for better reception, and turn it on using the power button. Use the mode button to select DAB or FM radio and follow the instructions in the manual to scan for stations.
Ensure the antenna is fully extended and positioned vertically. You might also try repositioning the radio near a window or away from electronic devices that could cause interference.
Check if the radio is properly plugged into a working power outlet. If it’s battery-operated, ensure the batteries are correctly installed and have charge. If the problem persists, consult the user manual or contact customer support.
Tune to your desired station, press and hold the preset button you wish to assign until you hear a confirmation beep. This will save the station to that preset number.
Check the volume level to ensure it is not set to the minimum. Verify that headphones are not plugged into the radio. If using an external speaker, check the connection.
Press the mode button on the radio to toggle between DAB and FM modes. The display will indicate the current mode.
To reset your radio, press and hold the menu button, navigate to the system settings, and select 'Factory Reset'. Confirm the reset when prompted.
Use a soft, dry cloth to wipe the exterior of the radio. Avoid using abrasive cleaners or solvents. Ensure the radio is unplugged before cleaning.
Check the manufacturer's website for any available firmware updates. If updates are available, follow the specific instructions provided to download and install the firmware.
Refer to the user manual to identify the specific error message. Follow the troubleshooting steps provided in the manual, or contact customer support for further assistance.