Sandstrom S1CRAD11E Instruction Manual

To set the time on your Sandstrom S1CRAD11E Clock, press and hold the 'Time Set' button until the hour digits flash. Use the 'Up' and 'Down' buttons to adjust the hour. Press 'Time Set' again to move to the minutes and adjust them using the same buttons. Press 'Time Set' once more to confirm.
Ensure the clock is properly plugged into a working power outlet. Check for any loose connections or damaged cables. If the issue persists, try a different outlet or check the internal battery if applicable.
To improve radio reception, try extending or repositioning the antenna. Avoid placing the clock near other electronic devices that may cause interference. If reception issues continue, consider relocating the clock to a different area with better signal strength.
Check if the alarm is set and activated. Ensure the volume is turned up and not muted. Verify that the alarm time is correctly set and that AM/PM settings are correct. If issues persist, reset the clock and set the alarm again.
To switch between 12-hour and 24-hour format, enter the time setting mode by pressing and holding the 'Time Set' button. Once in the mode, press the 'Mode' button to toggle between 12-hour and 24-hour formats. Confirm by pressing 'Time Set' again.
The Sandstrom S1CRAD11E Clock is primarily powered by AC power. However, it may have a battery backup feature to maintain time and alarm settings during a power outage. Check the user manual for battery installation instructions.
To adjust the alarm volume, locate the volume control buttons on the clock. Use these buttons to increase or decrease the volume to your desired level. You may need to check the user manual for specific button locations and instructions.
Check if the dimmer function is enabled and adjust the display brightness using the dimmer control. If the display is still dim, ensure the clock is receiving adequate power and the power cord is securely connected.
To reset the clock, locate the reset button, often found at the back or bottom of the unit. Press and hold the button using a pointed object for several seconds until the display resets. Consult the user manual for exact instructions.
Unusual noises may be due to mechanical issues or interference. Ensure the clock is placed on a stable surface, away from other electronics. If the noise persists, consider contacting customer support for further assistance.