Sandstrom SDW60B12 Instruction Manual

To reset the Sandstrom SDW60B12 dishwasher, press and hold the Start/Reset button for about 3 seconds until the control panel lights blink. This will cancel the current cycle and reset the dishwasher.
If the dishwasher is not draining, check the filter and drain hose for blockages. Ensure the drain hose is not kinked. Clean the filter if necessary and make sure the sink drain is clear.
To clean the filter, remove the bottom rack and twist the cylindrical filter counterclockwise to remove it. Rinse it under running water and use a soft brush to clean any debris. Reinstall by twisting clockwise.
Residue on dishes can be caused by overloading, using too little detergent, or using the wrong type of detergent. Ensure the spray arms are not blocked and clean the filters regularly.
To adjust the rinse aid settings, open the dispenser and turn the dial to the desired setting. Higher settings will increase the amount of rinse aid used per cycle, helping with water hardness and drying performance.
Ensure the dishwasher is properly plugged in and the door is securely closed. Check the circuit breaker and try resetting it. Make sure the Start button is pressed after selecting a cycle.
Unusual noises can be caused by items inside the dishwasher touching the spray arms. Ensure that dishes are loaded correctly, and check for loose parts or debris in the spray arms and filter.
It is recommended to clean the spray arms every 3 to 6 months. Remove them by unscrewing or unclipping, and rinse under running water to clear any blockages.
Yes, dishwasher tablets can be used in the Sandstrom SDW60B12. Place them in the detergent dispenser and ensure it closes properly. Tablets are effective for most water hardness levels.
To prevent odors, regularly clean the filter and run an empty hot water cycle with a cup of white vinegar. Ensure food debris is rinsed from dishes before loading.