Hoover VTS 712D21 2-80 User Guide

To start a quick wash cycle, turn the program selector dial to the 30-minute quick wash setting. Ensure the drum is not overloaded and press the start/pause button to begin the cycle.
Check the drain hose for any kinks or blockages. Additionally, clean the pump filter located at the bottom front of the machine by unscrewing the filter cap and removing any debris.
Remove the detergent drawer by pulling it out and pressing the release lever. Wash it with warm water to remove any detergent residue. Ensure it is completely dry before reinserting.
Regularly clean the detergent drawer, check and clean the pump filter, inspect the door seal for debris or mold, and ensure the drum is free of foreign objects.
Ensure the washing machine is level by adjusting the feet. Also, check that the load is balanced and not too heavy on one side. Avoid overloading the drum.
Foul odors may be due to mold or residue buildup. Run an empty hot wash cycle with a washing machine cleaner or white vinegar. Keep the door ajar after use to allow air circulation.
To reset the machine, unplug it from the power source for a few minutes, then plug it back in. This will reset the electronics and control board.
The maximum load capacity is 7 kg for cotton cycles. For delicate fabrics, it's recommended to reduce the load to avoid damage.
Error code E03 indicates a drainage problem. Check the drain pump and hose for blockages. Also, inspect the pump filter for any debris.
Yes, use the dedicated wool cycle setting. Ensure that the garments are labeled as machine washable and follow the care instructions on the label.