Hoover HWD 69AMBC 1-80 User Guide

To start the washing cycle, first load your laundry into the drum, add detergent, and select the desired wash program using the control panel. Press the 'Start' button to initiate the cycle.
Check if the machine is plugged in and the power supply is working. Ensure the door is closed properly and the 'Start' button is pressed. If the issue persists, check the circuit breaker or consult the user manual for troubleshooting tips.
Remove the detergent drawer by pulling it out. Wash it under warm water to remove any detergent residues. Dry it thoroughly before placing it back into the machine.
Ensure the machine is level on the floor. Check if the transit bolts are removed if the machine is newly installed. Also, make sure the laundry is evenly distributed in the drum.
Run an empty cycle at the highest temperature setting with a small amount of detergent or a washing machine cleaner to remove any build-up of detergent or limescale.
Foul smells can result from mold or bacteria build-up. Perform regular maintenance washes, clean the door seal, and leave the door open after each wash to allow the drum to dry.
Check the drain hose for any blockages or kinks. Inspect the pump filter for debris and clean it if necessary. Refer to the user manual for detailed instructions.
To reset, turn off the machine and unplug it from the power source. Wait a few minutes before plugging it back in and turning it on. This can help resolve minor electronic issues.
Error code E03 usually indicates a drainage issue. Check the drain hose and pump filter for blockages. If the problem persists, contact customer support for assistance.
To prevent tangling, avoid overloading the machine and use the appropriate wash program for your fabric type. Separating large and small items can also help reduce tangling.