Hoover DYN 10144DP-80 User Guide

To perform a quick wash cycle, turn the program selector knob to the 'Rapid 30' setting. Adjust the spin speed and temperature if necessary, then press the start button.
Check if the drain hose is kinked or clogged. Ensure that the filter is clean and not blocked by debris. Also, verify that the pump is functioning correctly.
Remove the detergent drawer by pulling it out gently. Wash it with warm water and a soft brush to remove any residues. Ensure it is completely dry before reinserting.
Loud noises during the spin cycle may be due to an unbalanced load. Make sure the laundry is evenly distributed and the machine is level. Check for any foreign objects in the drum.
Regularly clean the drum, detergent drawer, and door seal. Check and clean the filter monthly. Inspect hoses for leaks or wear and replace if necessary.
To reset the washing machine, turn it off and unplug it from the power source. Wait for a few minutes before plugging it back in and turning it on.
Ensure the cycle has completely finished, and check if the 'door lock' indicator light is off. If the door remains locked, unplug the machine and wait for a few minutes before trying again.
Run a maintenance wash using a drum cleaner or vinegar at a high temperature every month. Leave the door slightly open between washes to allow air circulation.
Check that the water supply is turned on and that hoses are not kinked. Ensure the inlet filter is not blocked and that the water pressure is adequate.
Select your desired wash program, then press the 'Delay Start' button to set the delay time. Press the start button to activate the delay.