Bang Olufsen Beocom 1401 v2 User's Guide

BeoCom 1401 RINGING SIGNAL BeoCom 1401 has 10 different settings for the ringing signal, consisting of 3 levels, 3 melodies and the ringing signal disconnected.

SETTING THE RINGING SIGNAL Press Enter Press Press 0-9 to select a setting Press Enter

When the ringing signal is disconnected (setting 0), it is automatically reconnected the first time you lift off the handset and place it in the base again.

ADJUSTING THE VOLUME During a call, you can adjust the handset volume in 5 steps by pressing the + and buttons. All calls start at the medium volume level.

Press + to increase the volume Press to decrease the volume

REDIALLING Press Rdl to redial the last number

called

Numbers with up to 31 digits can be memorized. Numbers stored in memory cannot be called by pressing Rdl.

In order to ensure that the last number called is stored correctly in the memory of BeoCom 1401 and can be redialled by pressing Rdl, the handset must have been placed in the base (or the switch off key on the bottom side of the handset pressed) for at least 1 second.

MICROPHONE Press to mute the

microphone A beeping signal in the handset indicates that the microphone is muted.

Press to connect the microphone

Please note! Pressing any other key once or twice will connect the micro- phone as well.

MEMORY BeoCom 1401 memorizes 10 tele- phone numbers which can be stored with code numbers from 0 to 9.

Numbers of up to 21 digits can be memorized.

If the telephone line is disconnected for more than 1 hour, numbers stored in the memory will be deleted. This may also happen when using a computer modem or another telephone on the same line.

STORING PHONE NUMBERS Press Enter Press Mem Enter the code number (0-9) Enter the phone number Press Enter

DIALLING A STORED NUMBER Press Mem Enter the code number (0-9)

DELETING A STORED NUMBER A stored number is deleted by storing a new number with the same code number.

SWITCHBOARD

STORING PHONE NUMBERS Press Enter Press Mem Enter the code number (0-9) Enter the phone number Press Enter

DIALLING A STORED NUMBER Press the prefix Press Mem Enter the code number (0-9)

REDIALLING A NUMBER Press the prefix Press Rdl

If the R-button is used for recalls, subsequent entries will not be stored for redialling.

Please note! The R/Flash-button may also be referred to in some instances as the Recall-button.

Slow

Normal

Fast

Disconnected

Low

1

4

7

0

Medium

2

5

8

High

3

6

9

Beocom

2

5

8

0

Vol

3

6

9

Mem

Enter

ABC DEF

GHI

PQRS

JKL

TUV

MNO

WXYZ

1

4

RRdl

Vol

7

Flash

ACCESSORY THE TABLE BASE The table base has 4 rubber feet. Each foot can be tipped up to allow the cord to be led out in the direction of your choice.

The cover plate can be tilted to rest on the tabletop. Under the cover plate, the writing pad and directory for your code numbers are placed.

PLACEMENT AND CLEANING Do not place the telephone in very dusty or dirty surroundings. Do not expose it to excessive moisture.

Clean the telephone with a firmly wrung, soft cloth dipped in water containing a few drops of mild detergent.

TECHNICAL SPECIFICATIONS Network analogue (PSTN) Power supply from the telephone

network Ambient temperatures -25oC +55oC Relative humidity 15% - 95% Supplier code N909

BeoCom 1401 is intended for use on public, analogue telephone networks.

Optimum telephone performance can only be expected in the country where your telephone was bought, as legal requirements for approv