Whirlpool WFG550S0LB Control Guide
![Whirlpool WFG550S0LB Range manual cover](/images/rqzSyljifYlCiWoBOkhqiOBp/thumbs/thumb175x175.webp)
To clean the grates, first remove them from the range. Soak them in warm, soapy water for 15-20 minutes, then scrub with a non-abrasive pad. Rinse thoroughly and dry completely before placing them back on the range.
First, check that the oven is set to the correct temperature and mode. Ensure the gas supply is on. If the issue persists, inspect the igniter and replace it if it's faulty. Refer to the user manual for detailed instructions or contact Whirlpool support.
Remove all oven racks and other items. Close the oven door and select the self-cleaning cycle from the control panel. Follow the prompts for cleaning duration, and allow the oven to cool completely before wiping away any ash residue.
Ensure the burner cap is properly aligned. Clean the burner and igniter with a dry brush to remove any debris. Check that the gas supply is turned on. If the problem remains, the igniter might need replacement.
To calibrate, press and hold the "Bake" button until the oven display shows the current calibration setting. Use the arrows to adjust the temperature up or down in increments of 5°F. Confirm the setting by pressing "Start".
Unusual noises can be due to loose parts or debris. Check and tighten any loose screws and clean the area around the burners and oven. If the noise persists, contact Whirlpool support for further assistance.
Ensure the oven is off and cool. Remove the glass light cover by turning it counterclockwise. Replace the bulb with a new 40-watt appliance bulb. Reattach the glass cover by turning it clockwise.
Perform surface cleaning after each use. Clean the oven monthly if frequently used, or use the self-cleaning feature as needed. Inspect and clean burners every few months. Annual professional maintenance is recommended.
Yes, the range can be converted to propane using a conversion kit. This should be done by a qualified technician to ensure safety and proper operation. Refer to the user manual for specific instructions and parts needed.
If the control panel is locked, press and hold the "Control Lock" button for 3 seconds until the lock icon disappears. This will unlock the panel and allow normal operation.