Vivotek AP-FHP-0100-R Quick Installation Guide

To set up the Vivotek AP-FHP-0100-R Extender, connect it to a power source and use an Ethernet cable to connect it to your router. Access the web-based setup page by entering the default IP address into your browser, and follow the on-screen instructions to configure your network settings.
Ensure that the extender is within the range of your router and that there are no obstacles blocking the signal. Restart both the router and the extender. If the problem persists, try resetting the extender to factory settings and reconfigure it.
To reset the extender, locate the reset button on the device, press and hold it for about 10 seconds until the LED indicators flash. This will restore the extender to its default factory settings.
The maximum range of the Vivotek AP-FHP-0100-R Extender is approximately 300 feet (about 90 meters) in open space. However, walls and other obstacles can reduce the effective range.
To update the firmware, log into the extender's web interface, navigate to the 'Firmware Update' section, and follow the instructions to download and install the latest firmware version. Ensure your extender is connected to a stable power source during the update.
The Wi-Fi signal may be weak due to physical obstructions, interference from other devices, or being too far from the router. Try moving the extender to a location with fewer obstructions and closer to the router.
Yes, the Vivotek AP-FHP-0100-R Extender is compatible with most standard routers. Ensure that your router supports WPS (Wi-Fi Protected Setup) for a simplified connection process.
During normal operation, the power LED should be solid, and the Wi-Fi LED should blink to indicate active data transmission. If the connection is stable, the signal strength LED will be solid.
To improve performance, position the extender in a central location, away from electronic devices that may cause interference. Additionally, ensure the firmware is up-to-date and configure the extender to use a less congested Wi-Fi channel.
Check for firmware updates and ensure the extender is within range of the router. Avoid placing the extender near devices that emit wireless signals. If the problem continues, reset the device and configure it again.