Toyota FJ Cruiser 2014 Quick Reference Guide

To reset the maintenance required light, turn the ignition to the "ON" position. Set the odometer to "ODO" mode, turn off the ignition, press and hold the trip meter reset button, and turn the ignition back to "ON." The light should flash and then go off.
The recommended tire pressure for the 2014 Toyota FJ Cruiser is 32 psi for the front and rear tires. It's best to check the tire pressure when the tires are cold.
To improve fuel efficiency, maintain regular engine tune-ups, keep tires properly inflated, drive at moderate speeds, and avoid excessive idling. Ensure that your air filter is clean and use the recommended grade of motor oil.
The recommended oil type for the 2014 Toyota FJ Cruiser is 0W-20 synthetic oil. This oil provides optimal performance and fuel efficiency. Always check your owner's manual for confirmation.
Engine overheating can be caused by a low coolant level, a faulty thermostat, a leaking radiator, or a failing water pump. It's important to check these components and consult a mechanic if necessary.
To program the keyless entry remote, insert the key into the ignition and cycle from "OFF" to "ON" five times. Open and close the driver's door twice, then remove the key. The locks should cycle, indicating the programming mode is active. Press any button on the remote to program it.
If the check engine light is on, check for any loose or damaged gas caps, as this is a common cause. If the light remains on, have the vehicle scanned with an OBD-II reader to identify any trouble codes. Consult a mechanic if necessary.
To replace the air filter, open the hood and locate the air filter housing. Release the clips or screws, remove the old filter, and insert a new one. Ensure the filter is seated properly before securing the housing.
The 2014 Toyota FJ Cruiser has a towing capacity of up to 4,700 pounds when properly equipped. Ensure your vehicle is equipped with the necessary towing package and follow all towing guidelines.
A squeaking noise could be caused by worn brake pads, loose belts, or suspension issues. Inspect these components for wear and tear, and replace or adjust as needed. If the noise persists, consult a professional mechanic.