Toyota Corolla 2017 Quick Reference Guide
![Toyota Corolla 2017 Sedan manual cover](/images/qquFpgmLNrtjkxLFCwfYoSAY/thumbs/thumb175x175.webp)
To check the engine oil level, park the vehicle on a flat surface and turn off the engine. Wait a few minutes for the oil to settle, then locate the dipstick near the engine. Pull it out, wipe it clean, reinsert it fully, and then remove it again to check the oil level. It should be between the 'Low' and 'Full' marks.
The 2017 Toyota Corolla Sedan typically requires 0W-20 synthetic oil for optimal performance and fuel efficiency. Always refer to the owner's manual for the most accurate information.
It is recommended to check the air filter every 15,000 miles and replace it every 30,000 miles under normal driving conditions. If you drive in dusty areas, consider replacing it more frequently.
The recommended tire pressures for the 2017 Toyota Corolla Sedan are typically 32 psi for the front tires and 30 psi for the rear tires. Check the placard on the driver’s side door jamb for exact specifications.
To reset the maintenance required light, turn the ignition to the 'ON' position without starting the engine. Press the trip meter reset button until the odometer reads "ODO." Turn off the ignition, then press and hold the trip meter reset button while turning the ignition back to 'ON.' Hold until the maintenance light disappears.
To improve fuel efficiency, ensure your tires are properly inflated, keep up with regular maintenance, drive at moderate speeds, and avoid excessive idling. Also, remove unnecessary weight from the car and use cruise control on highways when possible.
To jump-start your vehicle, first ensure both cars are turned off. Connect the positive jumper cable to the positive terminal of the dead battery, then to the positive terminal of the good battery. Connect the negative cable to the good battery's negative terminal, then to an unpainted metal surface on the Corolla. Start the assisting vehicle, then the Corolla.
To replace a headlight bulb, open the hood and locate the back of the headlight assembly. Disconnect the power connector from the bulb, remove the rubber dust cover, and unclip the bulb from its holder. Install the new bulb in the reverse order, ensuring not to touch the glass with your fingers.
If the check engine light comes on, check for any obvious issues like a loose gas cap. If nothing is apparent, have the vehicle's diagnostic codes read by a professional to determine the exact cause. Avoid driving under severe conditions until the issue is diagnosed.
To pair your smartphone, enable Bluetooth on your phone and in the Corolla's audio system. Select 'Setup' on the car's display, then 'Bluetooth,' and 'Add New Device.' Select your car's system on your phone and confirm the pairing code if prompted.