Sony SRS XG500 Operating Instruction
![Sony SRS XG500 manual cover](/images/b09b36bbfacb0d5d483057f0/thumbs/thumb175x175.webp)
To pair your Sony SRS XG500 with a Bluetooth device, turn on the speaker, press the Bluetooth button until you hear a pairing beep, and then select 'SRS-XG500' from the list of available devices on your Bluetooth device.
Ensure the speaker is in pairing mode and within range. If it still doesn't connect, try restarting both the speaker and the Bluetooth device, and delete any previous pairings on the device before attempting to reconnect.
To reset the Sony SRS XG500, press and hold the power button and the volume down button simultaneously for about 5 seconds until the speaker turns off. This will restore factory settings.
To clean the Sony SRS XG500, use a soft, dry cloth to wipe the exterior. Avoid using any chemicals or abrasive materials. Ensure all ports are closed when cleaning with a slightly damp cloth.
Press the Battery button on the speaker. The voice guidance will announce the remaining battery level. Alternatively, check the battery status via the Sony Music Center app.
Yes, you can use the Sony SRS XG500 while it is charging. However, using it while charging may increase the time required to fully charge the battery.
To update the firmware, use the Sony Music Center app. Connect your speaker to the app, and if an update is available, you'll be prompted to install it. Follow the on-screen instructions to complete the update.
Check if the speaker is turned on and the volume is not muted. Ensure the audio source is playing and the speaker is properly connected to the source device. Try reconnecting the Bluetooth or using a different audio cable if necessary.
The Sony SRS XG500 supports multipoint connection, allowing you to connect two devices simultaneously. However, audio can only be played from one device at a time.
The Sony SRS XG500 has an IP66 water resistance rating, meaning it is protected against dust ingress and powerful water jets, making it suitable for outdoor use.