LG LW5015E LW5015E.ASWAOSU Owner's Manual
![LG LW5015E LW5015E.ASWAOSU Air Conditioner manual cover](/images/BNIKPGFFVwAUNrppRnZZdBvK/thumbs/thumb175x175.webp)
To install the LG LW5015E, ensure the window is open wide enough for the unit. Secure the mounting brackets, slide the air conditioner into place, and extend the side curtains to fill the gaps. Finally, plug the unit into a power outlet.
First, check if the air filter is clean, as a clogged filter can reduce efficiency. Ensure that the temperature setting is lower than the room temperature, and that the unit is not blocked by furniture or curtains.
It is recommended to clean the air filter every two weeks during peak usage to maintain optimal performance. Simply remove the filter, wash it with warm water and mild detergent, rinse, and let it dry completely before reinserting.
Unusual noises can be due to loose parts or debris inside the unit. Ensure the unit is installed securely and check for any obstructions or debris. If the noise persists, contact a technician for further inspection.
Water leakage may occur if the unit is not tilted slightly backward. Ensure proper installation angle to allow water to drain outside. Also, check the drain hole for any blockages.
It is not recommended to use an extension cord with the air conditioner due to the risk of overheating and fire. Always plug the unit directly into a properly grounded outlet.
After a power outage, simply press the ‘Power’ button to turn the unit back on. The unit will retain its last settings. If it doesn’t start, check the circuit breaker and reset it if necessary.
Before storing, clean the filter, drain any water, and ensure the unit is dry. Cover it to prevent dust accumulation. Store the unit in a dry area to prevent corrosion and damage.
To change the temperature setting, use the temperature up and down buttons on the control panel or remote control. Adjust until the desired temperature is displayed.
To activate energy saver mode, press the 'Energy Saver' button on the control panel. This mode cycles the fan on and off with the compressor, conserving energy by maintaining the set temperature efficiently.