LG LSC27931SB Owner's Manual
![LG LSC27931SB Refrigerator manual cover](/images/BvzabwDDmMQmjOVDuYkKmSfd/thumbs/thumb175x175.webp)
To change the water filter, locate the filter compartment inside your refrigerator. Turn the old filter counterclockwise to remove it. Insert the new filter and turn it clockwise until it locks in place. Run water through the dispenser for about 2-3 minutes to clear any air and impurities.
First, check if the refrigerator is plugged in and the thermostat is set to the correct temperature. Ensure that the vents inside the fridge are not blocked. Clean the condenser coils located at the back or bottom of the fridge. If the issue persists, contact a technician.
To reset the ice maker, locate the on/off switch on the ice maker module. Turn it off for a few seconds and then turn it back on. You can also unplug the refrigerator for a few minutes and plug it back in to reset the system.
Water pooling can be caused by a blocked defrost drain. To fix this, unplug the refrigerator and locate the drain hole, usually found at the back of the fridge. Use a turkey baster to flush the drain with warm water and clear any blockages.
To adjust the temperature, press the "Refrigerator" or "Freezer" button on the control panel. Each press will adjust the temperature incrementally. Consult the user manual for the recommended temperature settings.
Loud noises can result from the compressor, evaporator fan, or condenser fan. Ensure the refrigerator is level and not touching any walls. Check for any loose components. If the noise persists, consult a professional technician.
It's recommended to clean the condenser coils every 6 months to ensure optimal performance. Use a vacuum cleaner or a soft brush to remove dust and debris.
To defrost, remove all food and unplug the refrigerator. Leave the doors open to allow the ice to melt naturally. Place towels around the base to catch any water. Once defrosted, clean and dry the interior before plugging it back in.
To replace the light bulb, unplug the refrigerator and locate the light cover inside. Remove the cover and unscrew the old bulb. Replace it with a new bulb of the same size and wattage, then reattach the cover.
Check if the door gasket is dirty or damaged. Clean it with warm soapy water and dry it thoroughly. If the gasket is damaged, it will need to be replaced. Ensure that the refrigerator is level for proper door alignment.