LG LFX25978SB Owner's Manual
![LG LFX25978SB Refrigerator manual cover](/images/GgwhqnrxCnmmynfDDOJExiwY/thumbs/thumb175x175.webp)
To change the water filter, locate the filter inside the refrigerator, usually in the upper right corner. Turn the filter counterclockwise to remove it. Insert the new filter and turn it clockwise until it is secure. Run water through the dispenser for about 2 minutes to remove any air and impurities.
First, check if the refrigerator is plugged in and the circuit breaker is not tripped. Ensure the temperature settings are correct. Clean the condenser coils located at the back or underneath the refrigerator. If the issue persists, contact LG customer support for assistance.
To reset the ice maker, locate the ice maker unit. Press and hold the reset button for about 3 seconds. The ice maker should make a noise indicating the reset process has started. Allow up to 24 hours for the ice maker to begin producing ice again.
A water leak can be caused by a clogged defrost drain or a damaged water line. Check the defrost drain for blockages and clear any debris. Inspect the water lines for cracks or leaks and replace them if necessary.
It's recommended to clean the condenser coils every 6 months to ensure optimal performance. Use a vacuum or a coil brush to remove dust and debris from the coils.
Noises may be due to the compressor, evaporator fan, or condenser fan. Ensure the refrigerator is level and not touching the wall or cabinets. If the noise persists, inspect the fans and replace them if they are faulty.
Ensure the refrigerator door seals are intact and clean. Set the temperature to the recommended settings: 37°F for the refrigerator and 0°F for the freezer. Avoid placing hot food directly inside and ensure proper air circulation around the unit.
Check for any obstructions on the shelves or in the door bins. Ensure the refrigerator is level and adjust the front leveling legs if necessary. Inspect the door gasket for damage and replace it if it is worn out.
To perform a factory reset, unplug the refrigerator from the power outlet. Wait for about 30 seconds, then plug it back in. This should reset the refrigerator to its default settings.
Store raw meat on the lower shelves to prevent contamination. Keep fruits and vegetables in the crisper drawers. Use airtight containers to store leftovers and label them with dates to ensure timely consumption.