Kenwood KSBSDB15 Instruction Manual

To adjust the temperature settings, press the temperature control buttons on the front panel until you reach the desired setting. The recommended temperature is 37°F (3°C) for the refrigerator and 0°F (-18°C) for the freezer.
First, ensure the refrigerator is plugged in and the power is on. Check the temperature settings to make sure they are set correctly. Clean the condenser coils if they are dirty, and ensure there is adequate airflow around the appliance.
To defrost the freezer, remove all items and unplug the refrigerator. Leave the freezer door open to allow the ice to melt naturally, or place a bowl of hot water inside to speed up the process. Once defrosted, clean and dry the interior before plugging the refrigerator back in.
Water leaks can be caused by a blocked defrost drain, a damaged water inlet valve, or a faulty door seal. Check these components and clean or replace them as necessary.
To change the light bulb, first unplug the refrigerator. Locate the light cover inside the unit, remove it, and unscrew the old bulb. Replace it with a new bulb of the same wattage and screw the cover back on.
Unusual noises can result from the compressor, fans, or other moving parts. Ensure the refrigerator is level and check for any loose components. If noises persist, contact a professional technician.
It's recommended to clean the condenser coils every 6-12 months to ensure optimal efficiency. Use a vacuum cleaner or a coil brush to remove dust and debris.
Store raw meats on the lower shelves to prevent drips onto other foods. Keep vegetables in the crisper drawers and dairy products in the main compartment. Make sure not to overcrowd the shelves to allow proper air circulation.
To reset the control panel, unplug the refrigerator from the power source, wait for about 5 minutes, and then plug it back in. This can help resolve minor glitches.
Check the ice maker's power switch to ensure it is turned on. Verify that the water supply line is connected and not kinked. If the issue persists, inspect for ice blockages in the ice maker mechanism and clear them as necessary.