Kenwood KNF55B17 Instruction Manual
![Kenwood KNF55B17 manual cover](/images/IXgzBnprmsWdSrXZAsrlSVhu/thumbs/thumb175x175.webp)
To adjust the temperature, locate the control panel inside the refrigerator. Use the up and down arrows to set your desired temperature. The recommended setting is between 3°C and 5°C for the refrigerator compartment.
First, check if the refrigerator is plugged in and the power is on. Ensure that the doors are closing properly and the seals are intact. Clean the condenser coils at the back of the unit. If the issue persists, consult a professional technician.
The Kenwood KNF55B17 Refrigerator features a frost-free freezer, so manual defrosting is not required. However, it's good practice to clean the freezer every six months to maintain efficiency.
Use a mixture of mild detergent and warm water to wipe down the interior surfaces. Avoid abrasive cleaners. Ensure all shelves and compartments are dried thoroughly before replacing them.
To change the light bulb, unplug the refrigerator. Locate the light cover inside the fridge, remove it, and unscrew the old bulb. Replace it with a new bulb of the same type and wattage, then reinstall the cover.
Water pooling can occur if the defrost drain is clogged. Clean the drain hole using a pipe cleaner or similar tool. Ensure the refrigerator is level to allow proper drainage.
Unusual noises could be due to the refrigerator not being level. Check if it is placed on a stable surface. If noises persist, ensure that the internal components are not vibrating against each other.
Ensure the door seals are intact and clean. Avoid placing hot food directly into the refrigerator. Keep the unit away from heat sources and allow sufficient space around it for air circulation.
Store raw meat on the lower shelves to prevent dripping onto other foods. Use airtight containers to reduce odors. Keep fruits and vegetables in the designated crisper drawers.
After a power outage, the refrigerator should resume normal operation automatically. If it does not, unplug it for a few minutes, then plug it back in to reset the system.