Hotpoint H1NT 811E OX 1 Safety Instructions

To set the temperature, use the control panel located inside the fridge compartment. Adjust the fridge temperature to around 3-5°C and the freezer to -18°C for optimal performance.
Check if the appliance is plugged in and switched on. Ensure the doors are closed properly and seals are intact. If the problem persists, check the temperature settings and ensure the vents are not blocked.
The freezer is frost-free, so manual defrosting is not typically required. However, if frost builds up, it could indicate a problem with the door seals or temperature settings.
Turn off the appliance and remove all food. Use a solution of mild detergent and warm water to wipe down the interior surfaces. Rinse with clean water and dry with a soft cloth before turning the appliance back on.
Ensure the fridge is unplugged. Locate the light cover inside the fridge compartment, remove it, and replace the bulb with a new one of the same type and wattage. Replace the cover and plug the fridge back in.
Some noise is normal due to the compressor and fan operation. However, unusual sounds could indicate blocked vents, the appliance not being level, or items inside vibrating against each other. Adjust as necessary to reduce noise.
Ensure the appliance is placed in a cool, well-ventilated area away from direct sunlight and heat sources. Keep the doors closed as much as possible and ensure the seals are intact.
Check if the water supply is connected and turned on. Ensure there are no kinks in the water line and that the water filter is not clogged. Replace the filter if necessary.
To reset the alarm, check and close the doors properly. If the alarm continues, check the temperature settings and ensure no items are blocking the door from closing.
The approximate dimensions are 188.9 cm in height, 59.5 cm in width, and 65.5 cm in depth. Always refer to the product manual for precise measurements.