Bush 4908861 AG56TB Operating and Installation Instructions
![Bush 4908861 AG56TB Cooker manual cover](/images/huAWkrGXVRjRFFRmMsRsabbK/thumbs/thumb175x175.webp)
To clean your Bush 4908861 AG56TB Cooker, first ensure the appliance is turned off and cooled down. Use a mild detergent with a soft cloth for the exterior. For the interior, remove racks and soak them in warm soapy water. Wipe the interior with a non-abrasive sponge. Avoid using harsh chemicals.
If the oven doesn't heat up, check if it is properly connected to the power supply. Ensure that the timer is not set to 'Auto' as this may prevent manual operation. If the issue persists, it might be a faulty heating element or thermostat, and you might need professional service.
To change the oven light, make sure the oven is off and cooled. Remove the glass cover by unscrewing it, then replace the bulb with a new one of the same type and wattage. Screw the glass cover back on securely.
To set the timer, press the 'Timer' button and use the '+' or '-' buttons to adjust the time. Confirm the setting by pressing the 'Timer' button again. The timer will count down and alert you when the time is up.
Uneven cooking can be caused by improper rack positioning or overloading the oven. Ensure the oven racks are placed correctly and do not block airflow. For best results, avoid overcrowding and use recommended cookware.
It's normal to notice a smell when using the cooker for the first time. This is due to the burning off of protective coatings and dust. To minimize this, operate the oven at a high temperature for about an hour with good ventilation.
Regular cleaning is key. After each use, wipe the door with a damp cloth to remove grease buildup. For tougher stains, use a mixture of baking soda and water, then rinse thoroughly.
For the best cooking results, use cookware with flat bases that cover the heating elements. Avoid warped or oversized pans, as they can lead to uneven cooking and energy inefficiency.
To move the cooker, first disconnect it from the power supply. Slide it gently away from the wall by pulling from a sturdy point. Use caution to prevent damaging the floor. Clean underneath and slide it back carefully.
If the control knobs are stiff, they may need cleaning. Pull the knobs off gently and clean them with warm soapy water. Ensure the control panel is clean and dry before replacing the knobs.