Worcester Greenstar 30CDi Classic System 2015 User Instructions

To reset the boiler, press the reset button located on the front panel of the boiler. Hold the button for 3 seconds until the reset light turns off.
An EA error code indicates a flame detection issue. Check that the gas supply is turned on, and reset the boiler. If the problem persists, contact a qualified technician.
It is recommended to service the boiler annually by a certified heating engineer to ensure it operates efficiently and safely.
The ideal pressure for the boiler is between 1.0 and 1.5 bar when the system is cold. Check and adjust the pressure using the filling loop if needed.
Turn off the heating system and wait for the radiators to cool. Use a radiator key to open the bleed valve slightly until water starts to trickle out, then close it.
Check if the boiler is turned on and the thermostat is set correctly. Ensure there is enough pressure in the system, and reset the boiler if necessary.
Regular maintenance, using a smart thermostat, and ensuring your home is well-insulated can improve energy efficiency. Consider upgrading to newer models if necessary.
A steady blue light means the boiler is operating normally. If it's flashing, it indicates a fault, and you may need to reset the boiler or consult a technician.
Some noise is normal, but if you hear banging or unusual sounds, it may indicate air in the system or a component issue. Have it checked by a professional.
Adjust the thermostat to a low temperature or switch off the central heating system entirely while keeping the hot water function active.