Whirlpool WRF560SMHZ Owner's Manual
![Whirlpool WRF560SMHZ Refrigerator manual cover](/images/acrDwDulzvFWsWcgADSZQjvm/thumbs/thumb175x175.webp)
To change the water filter, locate it in the upper right corner of the refrigerator compartment. Turn the filter counterclockwise to remove it. Insert the new filter and turn it clockwise until it locks in place. Run water through the dispenser for a few minutes to clear any air and impurities.
Check if the refrigerator is plugged in and the circuit breaker is not tripped. Ensure the temperature settings are correct. Clean the condenser coils and check the door seals for any gaps. If the problem persists, contact Whirlpool customer support for further assistance.
It is recommended to clean the condenser coils every six months to ensure optimal performance and energy efficiency. Use a vacuum cleaner or a coil brush to remove dust and debris.
The recommended temperature setting for the refrigerator is 37°F (3°C) and 0°F (-18°C) for the freezer. Adjust as necessary depending on the ambient temperature and refrigerator load.
To reset the ice maker, locate the on/off switch or button (usually on the side of the ice maker), turn it off for a few seconds, and then turn it back on. If this does not resolve the issue, consult the user manual or contact support.
Water pooling can be caused by a blocked defrost drain. Check the drain located at the back of the refrigerator compartment and clear any obstructions with warm water. If the problem continues, seek professional help.
To adjust the shelves, remove any items, tilt the shelf up, and lift it out of the shelf supports. Position the shelf at the desired height and press down until it locks into place.
The Whirlpool WRF560SMHZ refrigerator typically uses LED lighting. If a replacement is needed, refer to the user manual for the specific bulb type and installation instructions.
To activate Sabbath mode, press and hold the "Options" button until the Sabbath mode symbol appears on the display. This mode will disable lights and sounds for observance. To deactivate, repeat the process.
If the control panel is unresponsive, try resetting the refrigerator by unplugging it for a few minutes and then plugging it back in. If the issue persists, consult the user manual or contact Whirlpool customer support.