Whirlpool WGD6120HC Owner's Manual

To clean the lint trap, locate it at the bottom of the door opening. Pull it out, remove any lint by hand, and rinse it under warm water if necessary. Ensure it is completely dry before reinserting it into the dryer.
First, check if the dryer is properly plugged in and the circuit breaker is not tripped. Ensure the door is fully closed and the start button is pressed firmly. If the problem persists, contact a technician.
To prevent wrinkling, remove clothes promptly after the cycle ends. Use the Wrinkle Shield™ option, which tumbles clothes intermittently after the cycle to prevent wrinkles.
Clean the lint screen after every load, check the vent system for obstructions monthly, and wipe down the drum and exterior with a damp cloth as needed.
Ensure the lint screen is clean and check the exhaust vent for blockages. Overloading the dryer can also cause longer drying times. Consider reducing the size of the load.
Load a few garments, select the Steam Refresh cycle on the control panel, and press start. This cycle helps reduce odors and light wrinkles.
Signs include longer drying times, clothes feeling hotter than usual at the end of the cycle, and the dryer or laundry room becoming excessively hot.
Select a manual cycle and use the time-adjustment buttons to increase or decrease the drying time according to your needs.
Immediately stop the dryer and unplug it. Check for lint buildup in the lint trap and vent system. If the problem continues, contact a service technician.
Yes, but use a low heat setting and consider placing them inside a dryer bag or pillowcase to reduce noise and potential damage to the drum.