Sony SAT-T60 Installation Guide
![Sony SAT-T60 manual cover](/images/47779021a6852b0386e07d75/thumbs/thumb175x175.webp)
To connect your Sony SAT-T60 to your TV, use the RCA composite cables. Connect the yellow cable to the video output on the SAT-T60 and to the video input on your TV. Then, connect the red and white cables to the audio outputs on the SAT-T60 and to the audio inputs on your TV. Make sure to select the corresponding input on your TV.
First, check all cable connections to ensure they are secure. If the problem persists, try resetting the SAT-T60 by unplugging it from the power source for 30 seconds, then plugging it back in. If the issue continues, verify that your satellite dish is properly aligned and not obstructed.
To perform a factory reset on the SAT-T60, press the "Menu" button on your remote. Navigate to "Setup," then select "System Reset." Follow the on-screen instructions to complete the reset process. Please note that this will erase all your settings and recorded programs.
If your SAT-T60 remote is not working, start by replacing the batteries. If it still does not work, try resetting the remote by removing the batteries and pressing all the buttons twice. Reinsert the batteries and test the remote again.
To schedule a recording, press the "Guide" button on your remote to access the program guide. Select the program you wish to record and press the "Record" button. You can also set recurring recordings by selecting "Record Options" and choosing the frequency of the recording.
If your SAT-T60 is freezing, try a soft reset by pressing and holding the power button on the front panel for 10 seconds. If this does not resolve the issue, perform a hard reset by unplugging the device for 30 seconds and then plugging it back in.
The SAT-T60 updates its firmware automatically when connected to an active satellite signal. Ensure your device is connected and powered on. You can check for updates manually by going to "Setup" and selecting "System Information" to verify the current software version.
Poor picture quality can be due to loose connections or signal issues. Check that all cables are securely connected. If the problem persists, check the alignment of your satellite dish and ensure there are no obstructions. You can also try adjusting the video settings on your SAT-T60.
Yes, you can use a universal remote to control your SAT-T60. You'll need to program the remote with the correct code for the SAT-T60, which can be found in the universal remote's manual. Follow the programming instructions specific to your remote.
To access DVR recordings, press the "List" or "Recorded TV" button on your remote. This will bring up a list of recorded shows. Use the arrow keys to navigate through the list and select the program you wish to watch. Press "Play" to start viewing.