Poulan Pro PP927ESA Operator's Manual
![Poulan Pro PP927ESA Tractor manual cover](/images/PcJKjjlLuKMBgnzYmFDcbtnP/thumbs/thumb175x175.webp)
To start the Poulan Pro PP927ESA tractor, ensure the parking brake is engaged, the gear shift lever is in neutral, and the throttle lever is set to ‘Choke’ for a cold engine. Turn the ignition key to the start position and hold until the engine starts. Release the key immediately after the engine starts.
If the tractor won't start, check the battery connections for corrosion, ensure the fuel tank has fresh gasoline, and verify that the spark plug is clean and functional. Also, make sure the safety switches are engaged and check the fuse.
Uneven cutting can be caused by a misaligned deck, dull blades, or uneven tire pressure. Check that the deck is level, sharpen or replace the blades, and ensure all tires are inflated to the recommended pressure.
Regular maintenance includes checking the engine oil before each use, changing the oil every 50 hours of operation, cleaning the air filter every 25 hours, and replacing it every 100 hours. Sharpen blades and check the battery every season.
To change the oil, run the engine for a few minutes to warm it up, then turn it off. Place a pan under the oil drain valve, open the valve, and let the oil drain completely. Replace the oil filter, close the valve, and refill with new oil to the recommended level.
Check the PTO (Power Take-Off) switch to ensure it's functioning properly. Inspect the belt for wear or damage and replace if necessary. Also, verify that the connections to the PTO clutch are secure.
To adjust the mower deck, park the tractor on a level surface and lower the deck to the desired height. Use a socket wrench to adjust the lift links on both sides of the deck until it is level from side to side and front to back.
The Poulan Pro PP927ESA tractor requires unleaded gasoline with a minimum octane rating of 87. Avoid using gasoline with more than 10% ethanol content to prevent engine damage.
To replace the drive belt, first disconnect the battery and remove the mower deck. Loosen the belt guides and release the tension on the belt. Remove the old belt and install the new belt according to the routing diagram in the manual. Re-tension the belt, tighten the guides, and reattach the mower deck.
Excessive vibration can be caused by unbalanced or damaged blades, loose hardware, or worn belts. Check the blades for damage and balance them if necessary. Tighten any loose bolts and inspect the belts for wear.