Poulan Pro PP291EPS30 Operator's Manual

Ensure the fuel tank is filled and the oil level is correct. Insert the ignition key, set the choke to full, and press the primer bulb a few times. Pull the starter handle or use the electric start button if available.
Check the fuel and oil levels, ensure the ignition key is inserted, and verify that the choke is set to the appropriate position. Inspect the spark plug for wear or damage and replace if necessary.
Change the oil after the first 5 hours of use and then every 50 hours or at the beginning of each season. Always use the oil type recommended in the user manual.
Drain the fuel tank or add a fuel stabilizer, change the oil, and clean the exterior. Store in a dry, cool place and cover to protect from dust and moisture.
Check the auger drive belt for wear or damage, make sure the cable is properly adjusted, and ensure there are no obstructions in the auger housing.
Inspect for loose bolts and nuts, check the impeller and auger for ice buildup or damage, and ensure that the engine is securely mounted.
Ensure the chute is clear of obstructions, check the auger and impeller for damage, and verify that the engine is running at full throttle.
Regularly check and tighten bolts, change the oil and spark plug as needed, lubricate the auger and impeller, and inspect belts for wear.
Loosen the skid shoe bolts, adjust the height to leave a small gap between the scraper bar and the ground, then retighten the bolts ensuring both sides are even.
Use fresh, unleaded gasoline with an octane rating of 87 or higher. Avoid using gasoline with more than 10% ethanol content to prevent engine damage.