Poulan Pro GTI17T Operator's Manual

To start the Poulan Pro GTI17T Trimmer, ensure the power switch is in the "on" position, press the primer bulb six times, and then pull the starter handle briskly until the engine starts.
Use a mixture of unleaded gasoline and 2-cycle oil at a ratio of 40:1 for the Poulan Pro GTI17T Trimmer.
To replace the trimmer line, remove the spool from the trimmer head, wind the new line around the spool, and then reattach the spool to the trimmer head.
First, check the fuel level and ensure the fuel mixture is correct. Then, check the spark plug for damage or wear, and clean or replace it as necessary.
Clean the air filter regularly by removing it from the trimmer, washing it with soap and water, and allowing it to dry completely before reinstalling.
Perform regular maintenance such as checking and cleaning the air filter every 10 hours of use, inspecting the spark plug every 25 hours, and replacing it annually.
Ensure you are using the correct line diameter and type. Also, check for debris in the trimmer head and clear any obstructions that may cause the line to snap.
The Poulan Pro GTI17T Trimmer is compatible with certain attachments such as edgers and blowers, but always check the compatibility before use.
Drain the fuel tank, clean the trimmer thoroughly, and store it in a dry place. It is also advisable to remove the spark plug and apply a small amount of oil in the cylinder to prevent rust.
Always wear protective eyewear, gloves, and long pants. Ensure the work area is clear of debris and bystanders, and always follow the manufacturer's safety instructions.