Murray 46569x6B Parts Manual
![Murray 46569x6B Tractor manual cover](/images/xZkirrdULltTkfmROLfnzFSC/thumbs/thumb175x175.webp)
To change the oil, first run the engine for a few minutes to warm it up. Turn off the engine and remove the oil drain plug, allowing the old oil to drain completely. Replace the drain plug and refill the engine with fresh oil as per the manufacturer's specifications.
Use SAE 30 oil for temperatures above 32°F and 10W-30 oil for temperatures below 32°F, as recommended by the manufacturer.
Check the battery connections for corrosion or looseness, ensure the fuel tank is filled with fresh gasoline, and inspect the spark plug for damage or wear. Replace any faulty components and try starting the engine again.
Blades should be sharpened at least once per mowing season, or more frequently if you notice uneven cutting or tearing of the grass instead of clean cuts.
The recommended tire pressure is typically 10-14 PSI for the front tires and 8-10 PSI for the rear tires. Check the owner's manual for specific details.
Remove the air filter cover and take out the filter. If it's a paper filter, tap it gently to remove dust, or replace it if it's very dirty. For foam filters, wash in warm, soapy water, rinse, and allow to dry before reinstalling.
Ensure the blades are sharp and balanced, and check that the mower deck is level. Also, make sure you’re mowing at the correct speed and height for the grass conditions.
First, disconnect the spark plug for safety. Remove the mower deck and locate the drive belt. Release the tension on the belt by adjusting the tensioner pulley, then remove the old belt and install the new one, ensuring it is seated correctly in all pulleys.
Clean the tractor thoroughly, change the oil, stabilize the fuel, remove the battery and store it in a cool, dry place, and cover the tractor to protect it from dust and moisture.
Excessive vibration could be due to unbalanced or damaged blades, loose engine mounting bolts, or worn-out bearings in the mower deck. Inspect these areas and make necessary repairs or replacements.