Murray 46379x71A Parts Manual
![Murray 46379x71A Tractor manual cover](/images/nztNcNTthFwdcBUuAMeCZkvU/thumbs/thumb175x175.webp)
To start the Murray 46379x71A Tractor, ensure the transmission is in neutral and the parking brake is engaged. Insert the key into the ignition switch and turn it to the 'Start' position. Release the key once the engine starts.
It is recommended to use SAE 30 oil for the Murray 46379x71A Tractor in temperatures above 32°F (0°C). For temperatures below 32°F, use SAE 5W-30 or 10W-30.
First, ensure the tractor is turned off and the spark plug wire is disconnected. Use a wrench to remove the blade bolt, then replace the old blade with a new one. Tighten the blade bolt securely before reconnecting the spark plug wire.
Check if the battery is charged and the connections are clean and tight. Ensure there is fuel in the tank and that the fuel valve is open. Inspect the spark plug for wear or damage and replace if necessary.
Perform routine maintenance every 25 hours of operation or at the beginning of each mowing season. This includes checking the oil, air filter, and blades, as well as cleaning the mower deck.
The recommended tire pressure for the Murray 46379x71A Tractor is typically between 10-14 PSI for the front tires and 10-12 PSI for the rear tires. Always check the manufacturer's guidelines.
Ensure the blades are sharp and properly balanced. Regularly clean the underside of the mower deck to prevent grass build-up, and adjust the cutting height to suit your lawn conditions.
Stop the tractor immediately and allow it to cool. Check for debris blocking the cooling fins and ensure the oil level is adequate. Inspect the air filter and clean or replace if necessary.
Clean the tractor thoroughly and remove any grass or debris. Add a fuel stabilizer to the gasoline and run the engine for a few minutes. Disconnect the battery and store it in a cool, dry place. Cover the tractor to protect it from dust and moisture.
Check for uneven tire pressure and adjust if necessary. Ensure the mower deck is level and the blades are sharp and properly installed. Inspect for any obstructions under the deck that could affect cutting performance.