Honda Accord Sedan Touring 2014 Technology Reference Guide
![Honda Accord Sedan Touring 2014 Technology manual cover](/images/c36b4388461ea485e7120e1f/thumbs/thumb175x175.webp)
To pair your phone, ensure Bluetooth is enabled on your phone, then go to the 'Settings' menu in the car's infotainment system, select 'Phone', and follow the on-screen instructions to add a new device.
First, try restarting the system by turning the car off and then back on. If the issue persists, check for any available software updates through the Honda website or consult your owner's manual for troubleshooting steps.
To reset the maintenance minder, turn the ignition to the 'ON' position, press the 'Select/Reset' knob until the engine oil life indicator is displayed, then press and hold the knob until the indicator resets to 100%.
Honda recommends using 0W-20 viscosity grade oil for the 2014 Accord Sedan Touring to ensure optimal engine performance and efficiency.
Improving fuel efficiency can be achieved by maintaining proper tire pressure, avoiding excessive idling, using cruise control on highways, and following regular maintenance schedules.
To replace the key fob battery, remove the key from the fob, use a small screwdriver to pry open the fob, then replace the old battery with a new CR2032 battery, ensuring the positive side faces up.
You can adjust the head-up display brightness by using the controls located to the left of the steering wheel. Navigate through the display settings until you find the brightness option and adjust it accordingly.
If the air conditioning is not cooling, check the refrigerant levels, ensure the cabin air filter is clean, and verify that the AC system settings are correct. If these do not resolve the issue, a professional diagnostic may be necessary.
To enable or disable LaneWatch, go to the vehicle settings in the infotainment system, select 'Driver Assist System Setup', and then choose the LaneWatch settings to turn it on or off.
Open the hood and locate the back of the headlight assembly. Disconnect the power connector, remove the rubber weather seal, unclip the retaining clip, and replace the bulb. Reassemble in reverse order.