Dimplex Saletto LPP050E Product Guide

To turn on the Dimplex Saletto LPP050E Heater, ensure it is plugged into a power outlet. Use the power button on the control panel to switch it on.
Check that the heater is plugged in and the power switch is on. Ensure the thermostat setting is higher than the current room temperature. If the problem persists, consult the user manual or contact customer support.
Use the thermostat dial on the heater to adjust the temperature. Turn the dial clockwise to increase and counterclockwise to decrease the temperature setting.
The Dimplex Saletto LPP050E Heater is not designed for use in bathrooms or any areas with high moisture levels. Use only in dry, indoor environments.
Ensure the heater is turned off and unplugged. Use a soft, dry cloth to wipe down the exterior. Avoid using water or cleaning solutions directly on the heater.
The heater is equipped with overheat protection and a tip-over switch to automatically shut off if the unit is knocked over or becomes too hot.
To reset the heater, place it in an upright position and turn it off. Then, turn it back on to resume normal operation.
Yes, the Dimplex Saletto LPP050E Heater can be wall-mounted. Refer to the installation instructions in the user manual for proper mounting procedures.
It is recommended to clean the heater every few months and inspect it for any signs of damage. Ensure the vents are free from dust and debris to maintain optimal performance.
Some noise is normal due to the expansion and contraction of heating elements. If the noise is excessive or unusual, ensure the heater is on a stable surface and free from debris. If the issue persists, contact customer support.