DeLonghi D1016WM17 Instruction Manual

To start a washing cycle, first load your laundry into the drum, add detergent, and close the door securely. Select your desired wash program using the control dial, then press the start/pause button to begin the cycle.
Ensure that the power cord is plugged in and the power switch is turned on. Check if the door is closed properly and that the water supply is connected and turned on. If the problem persists, consult the troubleshooting section of the user manual.
To clean the filter, locate it at the bottom front of the machine. Open the filter cover, unscrew the filter cap, and remove any debris. Rinse the filter under running water and replace it securely before closing the cover.
Regularly clean the drum and door seal with a damp cloth. Use a washing machine cleaner monthly on a hot cycle with no laundry inside. Leave the door slightly ajar after each use to allow air circulation.
Loud noises may be caused by an unbalanced load. Try redistributing the laundry evenly in the drum. Also, check if the machine is level on the floor. If the noise persists, examine the drum for foreign objects.
Select the desired wash program and use the temperature button to cycle through the available temperature settings. The selected temperature will be displayed on the control panel.
First, check if the drain hose is kinked or blocked. Inspect and clean the pump filter. Ensure the drain hose is positioned correctly according to the user manual. If issues continue, contact customer service.
Yes, you can wash delicate fabrics by selecting the appropriate delicate or gentle cycle on the machine. Use a mild detergent and consider placing delicate items in a mesh laundry bag for added protection.
It's recommended to perform basic maintenance, such as cleaning the drum and filter, monthly. Check hoses and connections for leaks or damage every six months. Refer to the user manual for detailed maintenance guidelines.
To reset the machine, turn the program dial to the 'off' position, wait a few seconds, and then select a new program. If needed, unplug the machine for a minute before restarting.