Cadillac Escalade 2009 Owner's Manual
![Cadillac Escalade 2009 manual cover](/images/NRhToHexfTCSzhjXHTzHxnyZ/thumbs/thumb175x175.webp)
To reset the oil life monitor, turn the ignition to the ON position without starting the engine. Use the DIC controls on the steering wheel to navigate to the "Oil Life" screen. Press and hold the "SET/RESET" button until the display shows 100%.
The recommended tire pressure for the 2009 Cadillac Escalade is typically 35 psi for both the front and rear tires. Always refer to the sticker located on the driver's side door jamb for exact specifications.
To pair your phone, enable Bluetooth on your phone and make it discoverable. On the Escalade's infotainment system, select "Phone" > "Bluetooth" > "Pair Device". Follow the prompts and enter the PIN displayed on the screen into your phone.
For a 2009 Cadillac Escalade, it is recommended to use SAE 5W-30 synthetic oil. Always check the owner's manual for the manufacturer's specifications.
If the Check Engine light is on, use an OBD-II scanner to read the diagnostic trouble codes (DTCs). These codes will help identify the specific issue. If you're not comfortable doing this, consult a professional mechanic.
To replace the headlight bulb, open the hood and locate the back of the headlight assembly. Remove the cover and disconnect the electrical connector. Twist the bulb counterclockwise to remove it. Insert the new bulb and reassemble.
If the AC isn’t blowing cold air, check the refrigerant level as it might be low. Inspect the AC compressor and related fuses. If necessary, recharge the system or consult a professional for a thorough diagnosis.
It is recommended to change the air filter every 15,000 to 30,000 miles. However, if you drive in dusty conditions, consider checking and replacing it more frequently.
Steering wheel vibration can be caused by unbalanced tires, misaligned wheels, or worn suspension components. Have a professional inspect the vehicle to identify and resolve the issue.
To program a new key fob, insert the existing programmed key into the ignition and turn it to the ON position. Turn it back to OFF and remove the key. Within 10 seconds, insert the new key and turn it to ON. Once the security light turns off, the new key is programmed.