Cadillac Escalade ESV 2006 Owner's Manual
![Cadillac Escalade ESV 2006 manual cover](/images/sPfectEvcdzEYbeFqASPqycN/thumbs/thumb175x175.webp)
To reset the oil change light, turn the ignition to the "ON" position without starting the engine. Press the accelerator pedal fully three times within five seconds. The oil life will reset to 100% and the light should turn off.
The recommended engine oil for a 2006 Cadillac Escalade ESV is 5W-30. Ensure it meets the GM6094M standard for optimal performance.
To jump-start, connect the positive cable to the positive terminal on the dead battery, then the other end to the positive terminal on the good battery. Connect the negative cable to the negative terminal on the good battery, and the other end to an unpainted metal surface on the engine block of the dead vehicle. Start the good vehicle and let it run for a few minutes before attempting to start the Escalade.
The towing capacity of the 2006 Cadillac Escalade ESV is approximately 7,500 pounds, assuming proper equipment and configurations.
It is recommended to change the transmission fluid every 50,000 miles or as specified in your owner's manual for optimal performance and longevity.
The check engine light can illuminate due to various issues such as a loose gas cap, faulty oxygen sensor, or issues with the catalytic converter. It is advisable to have the vehicle scanned for diagnostic trouble codes (DTCs) for accurate troubleshooting.
Locate the fuse box, which is typically under the hood or behind the dashboard. Use the fuse diagram in the owner's manual to identify the blown fuse. Remove it using a fuse puller and replace it with a new fuse of the same amperage.
Common causes include leaving lights on, a faulty alternator, electrical shorts, or parasitic draws from aftermarket accessories. It's important to diagnose the issue by inspecting these components.
To improve fuel efficiency, maintain proper tire pressure, perform regular maintenance such as oil and air filter changes, avoid aggressive driving, and remove unnecessary weight from the vehicle.
To program a new key fob, insert the existing key and turn the ignition to the "ON" position. Within five seconds, insert the new key and turn it to "ON." The security light will turn off, indicating successful programming.