Acura TSX 2012 Advanced Guide
![Acura TSX 2012 Sedan manual cover](/images/qvMHfNJVQqjeEZwdNAqwBHgM/thumbs/thumb175x175.webp)
To reset the maintenance light, turn the ignition switch to the ON position. Use the Select/Reset knob to select the engine oil life indicator. Press and hold the knob for about 10 seconds, until the display begins to blink. Release the knob, then press and hold it again for about 5 seconds until the maintenance light resets.
The recommended oil type for the 2012 Acura TSX Sedan is 5W-20 synthetic motor oil. Always ensure to use oil that meets the API certification for your vehicle.
To improve fuel efficiency, ensure regular maintenance like timely oil changes, keeping tires properly inflated, reducing excess weight, and driving at moderate speeds. Also, using cruise control on highways can help enhance fuel efficiency.
The recommended tire pressure for the 2012 Acura TSX Sedan is typically 32 psi for both the front and rear tires. However, always refer to the sticker on the driver's side door jamb for the most accurate information.
To replace a headlight bulb, first open the hood and locate the back of the headlight assembly. Remove the electrical connector from the bulb, then twist the bulb counterclockwise to remove it. Insert the new bulb without touching the glass, then twist it clockwise to secure it. Reconnect the electrical connector.
Common causes for a check engine light include a loose gas cap, faulty oxygen sensor, catalytic converter issues, ignition coil problems, or mass airflow sensor failure. It's advisable to use an OBD-II scanner for precise diagnostics.
It is generally recommended to change the transmission fluid every 30,000 to 60,000 miles. Always refer to the vehicle's owner's manual for specific recommendations based on driving conditions.
The 2012 Acura TSX Sedan is not specifically designed for towing. It's important to consult the owner's manual and possibly consider an SUV or truck if towing is a frequent requirement.
To program a new key fob, insert the key into the ignition and turn it to the ON position. Press the "Lock" button on the key fob, then turn the key to the OFF position. Repeat this process three times. After the third cycle, the locks should cycle to indicate successful programming.
Signs of a failing alternator include dimming headlights, a dead battery, warning lights on the dashboard, unusual noises, and electrical issues. It's important to have the alternator tested if these symptoms are observed.