Viking VUBV515G Energy Guide
![Viking VUBV515G Refrigerator manual cover](/images/hwHahunIsYCLnhWgWorDuXkB/thumbs/thumb175x175.webp)
To adjust the temperature settings, locate the control panel inside the refrigerator. Use the up and down arrows to set your desired temperature for both the refrigerator and freezer compartments.
Unusual noises may be due to the refrigerator not being level. Make sure the unit is on a flat surface. Check for any loose items inside the refrigerator that might be vibrating. If the noise persists, contact Viking customer support.
It is recommended to clean the condenser coils every 6 months. This helps maintain efficient operation and prolongs the life of the refrigerator.
To change the water filter, turn off the water supply and twist the old filter counterclockwise to remove it. Insert the new filter and turn it clockwise until it is secure. Turn the water supply back on and run water through the dispenser for a few minutes to clear any air and impurities.
Ensure the door is closing properly and the seal is intact. Check the temperature settings and make sure the vents inside aren't blocked. If the problem persists, inspect the condenser coils for dust and debris, and clean if necessary.
Ensure the freezer door is closed tightly and avoid frequent opening. Check the door seal for any damage. Regularly defrost the freezer if ice buildup is excessive.
First, check if the bulb is burnt out and replace it if necessary. If the bulb is functional, inspect the light switch or contact a technician for further assistance.
To manually defrost, unplug the refrigerator and remove all items from the freezer. Leave the freezer door open to allow the ice to melt. Use towels to soak up water and wipe down the interior once the ice has melted completely.
Check the water supply line for leaks or damage. Ensure the drain pan is not full and is positioned correctly. If the leak persists, inspect the door seal for any gaps or damage.
To reset the control panel, unplug the refrigerator for a few minutes and then plug it back in. This should reset the system. If issues continue, consult the user manual or contact customer support.