Viking DDRB364 Energy Guide

To adjust the temperature, locate the control panel inside the refrigerator. Use the up and down arrows to set the desired temperature for both the refrigerator and freezer compartments.
First, check if the refrigerator is plugged in and the circuit breaker is not tripped. Ensure that the vents inside are not blocked and the door seals are clean and sealing properly. If the problem persists, consider contacting a professional technician.
Unplug the refrigerator and locate the condenser coils, usually at the back or bottom. Use a vacuum with a brush attachment to remove dust and debris gently. Clean at least twice a year for optimal performance.
To defrost manually, remove all contents and unplug the refrigerator. Leave the freezer door open and allow the ice to melt naturally. Clean the interior with a soft cloth before plugging it back in.
Locate the water filter compartment, usually inside the refrigerator. Turn the old filter counterclockwise to remove it. Insert the new filter and turn it clockwise until it locks into place. Run water through the dispenser for a few minutes to flush the system.
Water pooling could be due to a clogged defrost drain. Clear the drain by flushing it with warm water using a turkey baster. Ensure the refrigerator is level to prevent future pooling.
Regularly clean the condenser coils, inspect door seals for tightness, replace water filters as recommended, and defrost the freezer if necessary. Keep the refrigerator filled to optimize energy efficiency.
Ensure the ice maker is turned on and the water supply line is connected. Check for ice blockages and clear them. If the problem persists, inspect the water inlet valve or seek professional assistance.
Noises may be due to the refrigerator being unlevel or items vibrating inside. Ensure the refrigerator is on a level surface and that items are not touching the interior walls. If noises continue, inspect the condenser fan or compressor.
To reset the control panel, unplug the refrigerator for about 5 minutes, then plug it back in. Alternatively, consult the manual for specific reset instructions related to your model.