Viking VCFF136 Energy Guide
![Viking VCFF136 Refrigerator manual cover](/images/MXlllJeyCwEVqmIbMcSvNrSU/thumbs/thumb175x175.webp)
To adjust the temperature, locate the control panel inside the refrigerator. Use the arrow buttons to set your desired temperature. The recommended setting for the refrigerator is 37°F (3°C) and for the freezer is 0°F (-18°C).
First, check if the refrigerator is plugged in and that the circuit breaker has not tripped. Ensure the temperature settings are correct. Clean the condenser coils and check if the door seals are intact and not allowing air to escape. If the issue persists, contact a service technician.
It is recommended to clean the condenser coils every 6 months. This helps maintain efficient cooling and prolongs the lifespan of the refrigerator.
The Viking VCFF136 is equipped with an automatic defrost system. However, if you notice excessive frost buildup, you can manually defrost by turning off the refrigerator and leaving the freezer door open until the ice melts. Dry the interior with a towel before turning it back on.
Water pooling can be due to a blocked defrost drain. Clear any debris from the drain hole located at the back of the refrigerator's interior. If the drain is clogged, use a turkey baster to flush it with warm water.
Locate the water filter compartment inside the refrigerator. Turn the old filter counterclockwise to remove it. Insert the new filter and turn it clockwise until it locks into place. Run water through the dispenser for a few minutes to clear any air.
Ensure the ice maker is turned on and the water supply line is connected. Check for any ice blockages in the ice maker mechanism. If the problem persists, inspect the water inlet valve and ice maker control module for faults.
To improve energy efficiency, ensure the door seals are tight and undamaged. Keep the refrigerator away from heat sources and avoid opening the door frequently. Also, ensure the condenser coils are clean and free from dust.
To reset the control panel, unplug the refrigerator for about 5 minutes, then plug it back in. This should reset the system. If the issue remains, consult the user manual or contact customer support.
First, check if the bulb needs replacing. If the bulb is intact, inspect the door switch to ensure it is functioning properly. If neither is the issue, there may be a problem with the wiring, and a technician should be consulted.