Viking VCBF136 Energy Guide
![Viking VCBF136 Refrigerator manual cover](/images/mOlEMUEZgYhUdquhSOwNiXfQ/thumbs/thumb175x175.webp)
To adjust the temperature settings, locate the control panel inside the refrigerator. Use the up and down arrows to set your desired temperature for both the refrigerator and freezer compartments. It is recommended to keep the refrigerator at around 37°F and the freezer at 0°F.
First, check that the refrigerator is plugged in and the circuit breaker is not tripped. Ensure that the temperature settings are correctly adjusted. Clean the condenser coils located at the back of the unit and ensure that the door seals are not damaged or dirty, as this can affect cooling efficiency.
Condenser coils should be cleaned every 6 months to maintain optimal performance. Use a vacuum cleaner or a coil brush to remove dust and debris from the coils, which are located at the back of the refrigerator.
Store raw meats on the lowest shelf to prevent cross-contamination. Use airtight containers for leftovers and perishable items. Keep fruits and vegetables in the designated crisper drawers to maintain freshness. Ensure air circulation by not overfilling the refrigerator.
Ensure the ice maker is turned on and the water supply line is connected properly. Check for any ice blockages in the ice maker assembly. If the ice maker is not producing ice, try resetting it by turning it off and then on again.
Check if the water supply line connections are tight and not damaged. Inspect the drain pan and defrost drain for blockages. Make sure the refrigerator is level, as an uneven surface can cause water to leak.
Locate the water filter inside the refrigerator, typically in the upper right corner. Turn the filter counterclockwise to remove it. Insert the new filter and turn it clockwise until it locks into place. Run water through the dispenser for a few minutes to clear out any air and impurities.
Yes, the door swing direction can be changed. Refer to the user manual for detailed instructions. Typically, it involves removing the top hinge cover, unscrewing the hinges, and reattaching them on the opposite side. Be sure to have a helper to safely support the doors during this process.
The alarm indicator usually signifies that the refrigerator door has been left open for an extended period or that the internal temperature has exceeded safe levels. Make sure the door is properly closed and check the temperature settings.
To perform a factory reset, unplug the refrigerator from the power source and wait for about 5 minutes before plugging it back in. This will reset the internal control settings to their default values.