Viking FDSB5421 Energy Guide
![Viking FDSB5421 Refrigerator manual cover](/images/lTkQjJcgKTtJKNclUlhCqogo/thumbs/thumb175x175.webp)
To change the water filter, locate it inside the refrigerator compartment. Turn the filter counterclockwise to remove it. Insert the new filter and turn it clockwise until it locks into place. Run water through the dispenser for about 5 minutes to clear any air and impurities.
Ensure the refrigerator is plugged in and the thermostat is set to the correct temperature. Check for blockages in the air vents and clean the condenser coils. If the problem persists, the issue may be with the compressor or evaporator fan, requiring professional service.
Check if the refrigerator is level and ensure it is not in contact with any surrounding items. Noises can also come from the evaporator or condenser fan, which may need cleaning or replacement. Persistent issues may require professional inspection.
It is recommended to clean the condenser coils every 6 months to ensure efficient operation. Use a vacuum cleaner or a coil brush to remove dust and debris.
To reset the ice maker, first ensure it is turned on. Then, locate the reset button on the ice maker module, press and hold it for about 10 seconds until you hear a chime or the ice maker starts to cycle.
Use a solution of mild detergent and warm water to clean the interior surfaces. Avoid using harsh chemicals or abrasive cleaners. Rinse with clean water and dry with a soft cloth.
Check if the water filter is properly installed or clogged. Ensure the defrost drain is not blocked and inspect the door seals for damage. If the issue persists, there might be a problem with the water inlet valve or tubing.
Locate the temperature control panel inside the refrigerator. Use the buttons or dial to adjust the temperature settings for both the refrigerator and freezer compartments. Allow 24 hours for the temperature to stabilize after adjustments.
First, check if the refrigerator is properly connected to power. If it is, the light bulb may need replacing. Remove the cover, unscrew the old bulb, and replace it with a new one of the same type and wattage.
Keep the refrigerator away from heat sources and ensure it is well-ventilated. Maintain door seals in good condition and avoid frequent door openings. Regularly clean the condenser coils and set appropriate temperature levels.