Viking FDFB5301 Energy Guide
![Viking FDFB5301 Refrigerator manual cover](/images/pXAFKQrdUefOuLSudUCvAzXQ/thumbs/thumb175x175.webp)
To adjust the temperature, press the "Temperature" button on the control panel. Use the "+" and "-" buttons to set your desired temperature for both the refrigerator and freezer compartments.
Check if the refrigerator is plugged in, ensure the doors are closing properly, and verify that the temperature settings are correct. Also, clean the condenser coils located at the back of the unit.
It is recommended to clean the condenser coils every six months to ensure optimal performance and energy efficiency.
Water leaks can occur if the defrost drain is clogged. Clear any debris from the drain hole and ensure that the drain tube is not obstructed.
Locate the water filter compartment inside the refrigerator. Turn the filter counterclockwise to remove it, insert the new filter, and turn it clockwise until it locks in place.
Some noise is normal, but if you hear loud or unusual sounds, check for any loose items inside the refrigerator and ensure it is level. If the noise persists, contact a service technician.
Ensure door seals are tight, avoid opening the doors frequently, set the temperature to the recommended settings, and keep the condenser coils clean.
While the refrigerator can be installed in a garage, ensure the ambient temperature does not fall below 50°F or exceed 110°F to maintain optimal performance.
To reset the control panel, unplug the refrigerator for approximately five minutes, then plug it back in. This should reset the system.
Some condensation can be normal, especially in humid environments. Ensure the door seals are intact and reduce humidity in the area if possible.