Viking DDSF036 Energy Guide
![Viking DDSF036 Refrigerator manual cover](/images/okipPgVpKmwbnMuzqdbODDBY/thumbs/thumb175x175.webp)
To change the water filter, locate the filter compartment inside the refrigerator. Turn the old filter counterclockwise to remove it. Insert the new filter and turn it clockwise until it’s firmly seated. Run water through the dispenser for a few minutes to clear any air or contaminants.
Ensure that the refrigerator is plugged in and the thermostat is set correctly. Check the condenser coils for dust buildup and clean them if necessary. Verify that the door seals are intact and that the refrigerator is not overfilled, which could restrict air circulation.
To reset the ice maker, locate the on/off switch and turn it off. Wait a few minutes, then turn it back on. If the ice maker does not start producing ice, consult the user manual for further troubleshooting steps.
It is recommended to clean the condenser coils every six months, replace the water filter every six months, and check door seals regularly for wear and tear. Additionally, defrost the freezer if ice buildup exceeds 1/4 inch.
To defrost the freezer, remove all items and unplug the refrigerator. Leave the freezer door open to allow the ice to melt. Once defrosted, clean and dry the interior before plugging the refrigerator back in and restocking it.
Water pooling may be due to a blocked defrost drain. Check and clear any obstructions in the drain using a mixture of warm water and baking soda. If the issue persists, inspect the door seals for leaks.
Use a soft cloth and a stainless steel cleaner or a mixture of mild soap and water. Wipe in the direction of the grain to avoid streaks. Dry with a clean, dry cloth to prevent water spots.
Check if the refrigerator is properly plugged in. If it is, inspect the light bulb and replace it if it’s burnt out. If the light still doesn’t work, there may be an issue with the light switch or wiring, which may require professional service.
Locate the temperature control panel inside the refrigerator. Adjust the settings using the up or down arrows to reach the desired temperature. Allow 24 hours for the refrigerator to stabilize at the new temperature.
Refer to the user manual for a list of error codes and their meanings. Common codes may indicate issues with the temperature sensor, door switch, or defrost system. If the problem persists, contact Viking customer support for assistance.