Sauter SFE700WI User Manual
![Sauter SFE700WI Oven manual cover](/images/iZzIrzvKKxlMdWpdZcyuBPfM/thumbs/thumb175x175.webp)
To preheat the Sauter SFE700WI oven, turn the function selector to the desired cooking mode and set the temperature with the thermostat knob. Wait for the oven to reach the set temperature before placing your food inside.
If the oven is not heating properly, check that it is connected to the power supply. Ensure that the settings are correct and try resetting the circuit breaker. If the issue persists, consult the user manual or contact a technician.
To clean the interior of the Sauter SFE700WI oven, remove all racks and accessories. Use a mild detergent with warm water and a non-abrasive sponge to wipe down the surfaces. Avoid using harsh chemicals or scrubbing pads.
Regularly clean the oven, check the door seal for any damage, and ensure that the ventilation is clear. Perform a self-cleaning cycle if available and have the oven serviced annually by a professional.
To replace the oven light, ensure the oven is unplugged. Remove the glass cover by turning it counterclockwise. Replace the bulb with a new one of the same type and wattage, then reattach the glass cover.
If the oven door won't close properly, inspect the door seal and hinges for any obstructions or damage. Tighten any loose screws and replace damaged parts as necessary.
Refer to the user manual for specific error codes related to the Sauter SFE700WI oven. Common solutions include resetting the oven or checking connections. If unresolved, contact customer support.
Yes, you can use aluminum foil in the oven for cooking. However, avoid covering the bottom of the oven to ensure proper heat circulation and prevent damage.
To set the timer, use the timer knob or digital interface (depending on the model). Turn the knob or press the buttons to the desired time, and the timer will alert you when the time is up.
Common cooking modes include conventional cooking, fan-assisted cooking, grill, and defrost. These modes can be selected using the function selector on the control panel.