Roberts Expression DAB 2010 User Guide

To set up your Roberts Expression DAB 2010, plug the radio into a power source, extend the antenna, and press the power button. Use the 'Menu' button to select 'Auto Tune' to scan and store available DAB stations.
Ensure the power cable is securely connected to both the radio and the power outlet. Check if the outlet is working by trying another device. If the problem persists, consider resetting the radio by unplugging it for a few minutes.
For better reception, fully extend the antenna and place the radio in an open space away from electronic devices that might cause interference. You can also try repositioning the radio or moving it near a window.
To reset your radio, press the 'Menu' button, navigate to 'System Setup', select 'Factory Reset', and confirm your choice. Note that this will erase all preset stations and settings.
Check if the volume is turned up and ensure that the radio is not muted. Verify that headphones are not connected. If using external speakers, ensure they are properly connected and powered on.
Press the 'Alarm' button, select 'Alarm 1' or 'Alarm 2', and use the navigation buttons to set the desired time and alarm mode (DAB, FM, or buzzer). Confirm your settings by pressing the 'Select' button.
Ensure the antenna is fully extended and try repositioning the radio in a different location. Perform an 'Auto Tune' from the menu to rescan for available stations.
To store a station, tune to the desired station, press and hold one of the preset buttons (1-5) until the display confirms the station is saved. Repeat for additional stations.
Yes, the Roberts Expression DAB 2010 can operate on batteries. Open the battery compartment at the back, insert six 'C' size batteries, and ensure they are correctly oriented.
Check the Roberts Radio website for any available firmware updates for your model. Follow the provided instructions to download and install the update via a USB connection, if applicable.