Roberts Ecologic 15 Clock 2013 User Guide
![Roberts Ecologic 15 Clock 2013 manual cover](/images/3f46edb47b723c2428ba4b54/thumbs/thumb175x175.webp)
To set the alarm, press the 'Alarm' button until the alarm symbol appears on the display. Use the 'Hour' and 'Minute' buttons to set the desired time and confirm by pressing the 'Alarm' button again.
If the display is not lighting up, ensure the clock is connected to a power source. Check the brightness settings by pressing the 'Display' button to adjust the brightness level.
To switch between 12-hour and 24-hour format, press and hold the 'Time' button until the format starts flashing. Use the 'Hour' button to toggle between 12H and 24H, then press 'Time' to confirm.
First, check that the alarm is activated by ensuring the alarm symbol is displayed. Verify the time and AM/PM settings. If the problem persists, perform a factory reset by unplugging the clock for a few minutes and then setting it up again.
To perform a factory reset, unplug the clock from the power source for at least 30 seconds. Reconnect it and set the time and alarm settings again.
Yes, the Roberts Ecologic 15 Clock has a built-in FM radio. Press the 'Radio' button to turn on the radio, and use the 'Tuning' buttons to find your desired station.
To adjust the radio volume, use the 'Volume' buttons located on the front panel of the clock.
The Roberts Ecologic 15 Clock uses two AA batteries for backup. These batteries help maintain the clock settings during a power outage.
To improve radio reception, extend the FM antenna wire fully and adjust its position. Avoid placing the clock near electronic devices that may cause interference.
To set the sleep timer, press the 'Sleep' button repeatedly to select the desired duration (from 15 to 90 minutes). The radio will automatically turn off after the set time.